Receive email notifications by changing your settings.
Click on your picture in the top right corner, go to Preferences and select your notification preferences.
Click on your picture in the top right corner, go to Preferences and select your notification preferences.
Inlet not working
in Water
Hello,
I was wondering why my inlet does not produce any water.
The actual water level is 16,39 so that should not be a problem.
Comments
The inlet does produce water when I remove the lower threshold, but it seems necessary for the simulation to be accurate
Inlet not working
https://community.tygron.com/forum/discussion/480/inlet-not-workingHi @Niels Bolt ,
We will have a look and get back to you.
Regards, Vincent
Hi @Niels Bolt ,
To check/ debug your results, you can review the following:
- Object datum output (waterlevel at location inlet)
- Object flow output (shows amount of water flowing though inlet)
- Is 16,9 the actuel water level (surfacelastdatum) or configurated water level for the water area (water_level attribuut van water level area)?
I hope this helps.
Best, Vincent