Receive email notifications by changing your settings.
Click on your picture in the top right corner, go to Preferences and select your notification preferences.
Click on your picture in the top right corner, go to Preferences and select your notification preferences.
Thank you for contributing to our forum!
Please keep in mind:
1. To only comment on the topic where the discussion is about. Do you have a new question or topic? Please start a new discussion.
2. Be kind to other users!
Please keep in mind:
1. To only comment on the topic where the discussion is about. Do you have a new question or topic? Please start a new discussion.
2. Be kind to other users!
Viscosity
Hi,
Not quite sure, but I don't think it is possible to change the viscosity of the fluid. In most cases I model water and therefor it is sufficient. However, I might have a assignment where I would like to model a mud flow due to a dam failure. Could it be possible to change the viscosity of the fluid in the calculations?
Tagged:
Comments
Hi Ward,
It is not possible to change viscosity in the water module. You could look if there are some parameters you can change the flow of the water approximately compared to mud. Values like infiltration and evaporation can maybe help you with that but I connot say anything about the accuratecy the model will have. And I'm not sure if there are enough attibutes you can change to create a propper estimation of a mud flow.
Kind regards,
Hansje
Tygron support team